Signal buzzer is an add-on for your RedBot that gives your robot the ability to make awesome beep-boop noises or alerts when something interesting (or terrible) happens. The buzzer works by making use of two I/O pins on a controller board to create different noises based on the different frequency of I/O toggling. If you are using this buzzer on a RedBot, simply plug it in to one of the many 3-pin I/O ports and get your robot to make some noise.
The buzzer has a 3-pin header which connects directly to the RedBot Mainboard or via male to female jumper wires. Use the included RedBot library to detect sound alarms and make some noise.
Check out the entire RedBot family of productsHanyoung Nux STL series LED multi-level signal light (signal tower) uses bright LEDs as a cold, long-life and reliable light source. Each of the LED lamps can be set to continuous on or flashing by individual signals. An internal circuit flashes the red, amber and green sections at approximately 1Hz. Each section can be enabled separately. The buzzer is turned on/off by a separate signal. There is a lever to adjust the volume of the buzzer. LEDs give an expected service time of more than 100,000 hours and save energy.The integration of the modulSIGNAL70 signal tower into ASInterface
field bus systems is easily possible with the new
AS-Interface module type BAZ. The new AS-Interface module
BAZ is optionally available with standard-slave or the new A/B
technique.
The AS-Interface module with standard slave can address up
to 31 modules and maximum 4 modules on the signal tow
You can more by product like this Signal Buzzer, cheaper price from our shop
Reviews
There are no reviews yet.